VEHICLE CONTROLS
To Change a Setting
n
Models with Color Audio
Using the Driver Information Interface
1. Press the Home button.
2. Select Settings.
3. Select a setting option and make your preferred changes. Then press
the ENTER button.
Models with Display Audio
1. Press the Home button.
2. Select Settings.
3. Select a category.
4. Select a setting option, and make your preferred changes.
Setting the Clock
On vehicles with navigation, the time is automatically set using GPS signals.
To manually adjust the clock, use the following steps:
Models with Color Audio
1. Press and hold the MENU/CLOCK
button.
2. Select Adjust Clock, then press the
selector knob.
3. Rotate knob to change the hour, then
press the selector knob.
4. Rotate knob to change the minute, then
press the selector knob.
5. Press the selector knob to switch to
Set.
6. Press the selector knob to complete clock adjustment.
Models with Display Audio
1. Press the Home button.
2. Select Settings.
3. Select System.
4. Select Date & Time.
5. Select Set Date & Time.
78 |
6. Select Set Time.
7. Use the up and down arrows to set the hour and minute.
8. Press the Save button to set the time.
™
*1
HondaVAC
Clean up dry spills and debris inside your vehicle with the in-car vacuum
system.
Operating the Vacuum
n
1. Make sure the vehicle is in Park (P) with the parking brake set. The
vacuum can be used with the vehicle ON (engine running) or in
Accessory mode (engine NOT running).
2. Start the engine (ON) in a well ventilated, open area outside to minimize
the likelihood of carbon monoxide exposure OR set the power mode to
ACCESSORY.
3. Open the vacuum storage lid in the driver's side rear cargo area.
4. Pull out the vacuum hose and install one of the attachments if desired.
5. Press the power button and begin to vacuum (dry use only).
Accessory mode operation (without the engine running)
• After 7 minutes, an intermittent beep begins to sound as a time limit alert.
• After 8 minutes, a beep sounds PWR SAVE indicator comes on, and the
vacuum turns off. You must start the engine if you want to continue using
the vacuum. The vacuum will restart after the engine has been running
for about one minute.
VEHICLE CONTROLS
*1 - If equipped
| 79