Window Washer Fluid; Brake Fluid; Changing Wiper Blades - Honda 2018 ODYSSEY Owner's Manual

MAINTENANCE
Models with Auto Idle Stop: The battery installed in this vehicle is specifically
designed for a model with Auto Idle Stop. Using a battery other than this
specified type may shorten the battery life, and prevent Auto Idle Stop from
activating. If you need to replace the battery, make sure to select the specified
type. Ask a dealer for more details.

Window Washer Fluid

Check the amount of window washer fluid by looking at the reservoir. Fill if it is
low. Pour the washer fluid carefully. Do not overflow the reservoir.
If the washer fluid is low, a message appears on the Driver Information
Interface.
Do not use engine antifreeze or a vinegar/water solution in the windshield
washer reservoir. Antifreeze can damage your vehicle's paint. A vinegar/water
solution can damage the windshield washer pump.

Brake Fluid

The fluid level should be between the MIN and MAX marks on the side of the
tank. We recommend using Honda Heavy Duty Brake Fluid DOT 3.
Pour the fluid carefully.
If the fluid level is at or below the MIN mark, have a dealer inspect for leaks or
worn brake pads as soon as possible.
Brake fluid marked DOT 5 is not compatible with your vehicle's braking system
and can cause extensive damage.

Changing Wiper Blades

If the wiper blades leave streaks across the windshield, try cleaning them first
with a paper towel or soft cloth and wiper fluid. If the wiper blade rubber has
deteriorated, you should change the wiper blades.
1. Set the power mode to VEHICLE OFF.
2. While holding the wiper switch in the MIST position, set the power mode to
ON, then to VEHICLE OFF. Both wiper arms are now set to the maintenance
position.
150 |
3. Lift the driver side wiper arm first, then
the passenger side.
4. Press and hold the tab, then slide the
holder off the wiper arm.
5. Pull the wiper blade to the opposite
direction to slide it out from its holder.
6. Insert the flat side of the new wiper
blade onto the bottom part of the holder.
Insert the blade all the way.
7. Install the end of the wiper blade into
the end cap.
8. Slide the wiper holder onto the wiper
arm, then push down the lock tab.
9. Lower the passenger side wiper arm
first, then the driver side.
10. Set the power mode to ON and hold the wiper switch in the MIST positions
until both wiper arms return to the standard position.
Avoid dropping the wiper arm, as it may damage the windshield.
MAINTENANCE
| 151