Prepare The Faceplate - ReSound Match Series Technical Manual

Prepare the faceplate - VC Installation
Drill bit 0.159" or 4.038 mm
for the Analog VC hole
Mark target hole.
Make sure that VC is not
protruding too much above
the highest point of the
external side of faceplate.
Drill target hole.
Use Loctite 416 and glue
around the VC (internal
side). Let it cure.
Doc. No. 0175820 rev. F
Remove debris and insert
Analog VC
NOTE : Let the glue cure first
then operate the VC to ensure
that it is not frozen.
Page 12 of 16