Information about the documentation About this documentation • Read this documentation before initial operation or use. This is a prerequisite for safe, trouble-free handling and use of the product. • Observe the safety instructions and warnings in this documentation and on the product. •...
Page 6
Protection class II (double-insulated) Product information Hilti products are designed for professional use and may be operated, serviced and maintained only by trained, authorized personnel. This personnel must be specifically informed about the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by untrained personnel or if used not in accordance with the intended use.
Page 7
▶ Avoid body contact with earthed or grounded surfaces, such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. ▶ Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock.
Page 8
▶ Operations such as wire brushing, polishing or cutting are not recommended to be performed with this power tool. Operations for which the power tool was not designed may create a hazard and cause personal injury. ▶ Do not use accessories which are not specifically designed and recommended by the tool manufacturer.
Page 9
▶ Do not position your body in the area where power tool will move if kickback occurs. Kickback will propel the tool in direction opposite to the wheel’s movement at the point of snagging. ▶ Use special care when working corners, sharp edges etc. Avoid bouncing and snagging the accessory.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare parts, consumables and accessories approved by Hilti for use with the product can be found at your local Hilti Store or online at: www.hilti.group | USA: www.hilti.com...
DGH 130 Speed (controlled) 3,000 /min … 8,700 /min Disc diameter 130 mm Disc thickness 4 mm Noise information and vibration values in accordance with EN 62841 The sound pressure and vibration values given in these instructions were measured in accordance with a standardized test and can be used to compare one power tool with another.
2. Unplug the supply cord from the power outlet. 3. Press and hold down the arbor lockbutton. 4. Slacken the clamping nut. 5. Release the arbor lockbutton and remove the accessory tool. Adjusting the guard 1. Switch off the power tool. 2.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare parts, consumables and accessories approved by Hilti for use with the product can be found at your local Hilti Store or online at: www.hilti.group | USA: www.hilti.com Changing the grinding slats Change the grinding slats when they are worn.
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, your old tools, machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative for further information.
Need help?
Do you have a question about the DGH 130 and is the answer not in the manual?
Questions and answers