Figure 3-7 - Gdu Knob Function Example; Figure 3-8 - Data Entry Options (Examples) - Garmin G3X Touch Maintenance Manual

Electronic flight instrument system
Hide thumbs Also See for G3X Touch:
Table of Contents

Advertisement

2. Use the "Move Selector" knob or by touching the display panel to make selections and changes.
3. After all configuration changes have been made, use the "Save & Reboot" page to save all
changes and return to normal mode.
NOTE
For a complete description and breakdown of each Configuration Mode page, refer to the G3X
Touch EFIS Part 23 AML STC Installation Manual (190-02472-01).
3.2.2.1 GDU Knob
The GDU knob has dual concentric knobs; a small inner and a larger outer. GDU 460 has two knobs, one
on each side of the lower section, while GDU 470 has one on the right side of the lower section of the
GDU. The function of each knob on the lower bezel is context sensitive and is identified on the screen just
above the associated knob. If both inner and outer knobs have the same function, the function will be
displayed on the screen above the knob; for example, "Move Selector", "Scroll List", etc. may be
displayed. If the inner and outer knobs have the different functions that would be displayed on the screen.
As shown below in Figure 3-7, the outer knob is used to select a tab and the inner knob is used to scroll
down a list.
To cycle through different configuration pages:
To scroll to a particular page: Rotate either the large outer or small inner knob or use the touch
panel.
To select a page: Press/push the inner knob or touch the page on the display.
To navigate between different tabs on a page: Rotate the large outer knob or use the touch panel.
To scroll down a list/data field in a tab: Rotate the inner knob or use the touch panel.
To select a data field: Press/push the inner knob or use the touch panel.
3.2.2.2 Configuration Data Entry
To change the contents of a highlighted data field, use the either the pop-up keyboard, pop-up keypad,
pop-up slider bar or touch panel as applicable.
Maintenance Manual
G3X Touch EFIS Part 23 AML STC
Figure 3-7 – GDU Knob Function Example
Figure 3-8 – Data Entry Options (Examples)
Page 23
190-02472-02
Revision 2

Advertisement

Table of Contents
loading

Table of Contents