Garmin G3X Touch Maintenance Manual page 125

MFR Model
GDL 5XR RS-232
GTS 8XX RS-232
ARINC 429 (if
connected to
Software
GTX)
V4.10 and
later
Notes:
(3) Set type on transponder configuration page of the GDU in configuration mode if remote control of
Transponder on G3X GDU is desired.
(4) Only one ADS-B Source maybe configured at a time.
(5) If a GDL 50R/52R is installed with a GTX 33ES or GTX 335R, ensure UAT and 1090ES are
enabled (green indicator). Reference the G3X Touch EFIS Part 23 AML STC Installation Manual
(190-02472-01) for detailed configuration information.
(6) See Table B.2 for GNX 375 configuration information.
Maintenance Manual
G3X Touch EFIS Part 23 AML STC
Data G3X Configuration Setting
Format
ADS-B/TIS-B
GTX 345R Connected to Garmin
Navigator for Position Source for
ADS-B Out (2)
Transponder Configuration Page:
HSDB Devices: Enable "GTN" or
"GTS"
NOTE: No GSU configuration is
required
NOTE: "x" = Connected Port #
RS-232 Configuration Page:
RS-232 Port 'x': 'Connext 57600 Baud"
(GDU port connected to GDL) (2)
NOTE: "x" = Connected Port #
RS-232 Configuration Page:
RS-232 Port 'x': GTS Instrument Data
If a remote GTX that supports TIS-A is
installed disable as shown below:
Transponder Configuration Page:
TIS-A Traffic Data: "Disable"
If direct audio connection from GTS to
Audio Panel is wired, perform the
following:
Sound Configuration Page:
Traffic Audio: "Disable"
Traffic N/A Alert: "Disable"
Page B-7
Interfacing Equipment
Configuration Setting
N/A
GTS 8XX Traffic Display Destination
Page:
Enhanced COM Port: "RS-232 Port x"
If GTX is installed:
GTS 8XX Transponder 1
Communication Page:
A429 Primary TX/RX: set to "TX/RX
Channel x and Check HIGH SPEED"
GTS 8XX GPS Position Velocity Page:
A429 Primary RX: set to "RX Channel x
and Check HIGH Speed"
NOTE: "x" = Connected Port #
190-02472-02
Revision 2