Hirschmann RS20 Series User Manual page 7

V Only personnel that have received appropriate training should operate
this device or work in its immediate vicinity. The personnel must be ful-
ly familiar with all of the warnings and maintenance measures in these
operating instructions.
V Correct transport, storage, and assembly as well as careful operation
and maintenance are essential in ensuring safe and reliable operation
of this device.
V Only use umdamaged parts!
V These products are only to be used in the manner indicated in this ver-
sion of the manual.
V Any work that may have to be performed on the electrical installation
should be performed by fully qualified technicians only.
Warning!
LED- or LASER components according to IEC 60825-1 (2001):
CLASS 1 LASER PRODUCT.
LIGHT EMITTING DIODE - CLASS 1 LED PRODUCT.
Warning
LED LIGHT
DO NOT STARE INTO THE BEAM OR VIEW DIRECTLY
WITH OPTICAL INSTRUMENTS (e.g. lens, microscope).
Failure to observe this warning within a distance of 100 mm
can endanger your eyes. Light is emitted from the optical connections or
from the ends of the optical fibers that are connected to them. Light Emit-
ting Diode CLASS 2M, Wave length 650 nm, Power <2 mW, according to
IEC/CEI 60825-1:2003-10.
National and international safety regulations
U
V Make sure that the electrical installation meets local or nationally ap-
plicable safety regulations.
Note on the CE marking
U
The devices comply with the regulations contained in the following Euro-
pean directives:
89/336/EEC
Directive of the council for standardizing the regulations of member
states on electromagnetic compatibility (changed by RL 91/263/EEC, 92/
31/EEC and 93/68/EEC).
In accordance with the above-named EU directives, the EU conformity
declaration will be at the disposal of the relevant authorities at the follo-
wing address:
6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
RS20/RS30
Release 2.0 03/06