Special accessories
You can order the following accessories from your
specialist dealer:
BA 016 165
Pull-out system
Fully extendable telescopic pull-out
rack and pyrolysis-proof cast frame
Baking tray, enameled, ^" (15 mm)
BA 026 115
deep
BA 036 165
Wire rack, chrome-plated, without
opening, with feet
BA 226 105
Grill tray, enameled, 1]" (30 mm) deep
BA 046 115
Glass tray, 1" (24 mm) deep
BA 056 115
Heating element for baking stone and
roaster (230 V)
BA 056 125
Heating element for baking stone and
roaster (400 V)
BA 056 133
Baking stone
Including baking stone support and
pizza paddle (order heating element
separately)
BS 020 002
Pizza paddle, set of 2
GN 340 230
GN 2/3 cast aluminum roaster,
height 6 1/2" (165 mm), non-stick
(Order heating element and pull-out
system separately)
Use the accessories only as indicated. The manufacturer
assumes no liability for incorrect usage of the
accessories.
Remove any accessories that are not required during
operation from the cooking compartment. Bush for the
additional heating element at the back of the cooking
compartment: Always leave the cover in during normal
operation without the additional heating element.
Before using the appliance for the first time
Before using the appliance for the first
K
time
B e f o r e u s i n g t h e a p p l i a n c e f o r t h e f i r s t t i m e
I n this chapter, you can find out what you must do
before using your oven to prepare food for the first time.
First read the section entitled.
The appliance must be completely installed and
connected.
After connecting the appliance to the power supply, the
"Initial settings "menu will be displayed. Now you can now
configure your new appliance for initial set-up.
Notes
▯
The "Initial settings" menu will appear only after the
appliance has been connected to a power supply and
switched on for the first time, or if the appliance has
not been connected to a power supply for a number of
days.
Once the appliance has been connected to a power
supply, the GAGGENAU logo will appear first for
approximately 30 seconds. The "Initial settings" menu
will then appear automatically.
You can change the settings at any time in the basic
▯
settings. ~ "Basic settings" on page 34
Setting the language
The default language appears in the display.
1.
Select the desired display language with the rotary
selector.
2.
Confirm with ™.
Setting the time format
the two possible formats 24h and AM/PM appear in the
display. The default format is 24h.
1.
Set the required format with the rotary selector.
2.
Confirm with ™.
Setting the time
The time appears in the display.
1.
Set the required time with the rotary selector.
Confirm with ™.
2.
en-us
15