18.3 CHECKING THE BURNER
The burner needs no cleaning.
• Check the burner surface for damage, replace the burner if necessary.
•
•
•
POSITIONING THE ELECTRODES
a
Flame detection probe
Ignition electrode
b
c
Burner
Burner surface insulation
d
18.4 COMBUSTION PARAMETERS
discharge circuit ( A), and allows monitoring of the quality of the combustion products and
allowing checking of any recycling of the combustion products in case of coaxial pipelines.
•
• oxygen O2 or carbon dioxide CO2 concentration
• carbon monoxide CO concentration.
The temperature of the comburent air must be measured on the test point located on the air
B) by inserting the measurement sensor by about 9 cm (C).
CHIMNEY SWEEPER
B),
43
a
7690785.01 (1-05/18)
c
d
b