Baxi LUNA DUO-TEC MP+ 1.115 Instruction Manual For Users And Fitters page 12

SETTING PARAMETERS USING THE REMOTE CONTROL
Turn knob B
Press knob B
Press button A or C
KEY TO FIGURE MENU
1 Enduser
2
Commissioning
The following procedure is used to access the four boiler
programming menus:
• from the main menu
• A and C (hold down for approx. 6 seconds)
B menu 1-2-3-4
• C to go back one menu at a time to the main menu.
When the Control Panel is wall-mounted enable the room
sensor and
A) ROOM SENSOR
• Access menu 2.
• B Operator unit
• programme row 40 (Used as)
B
• B (anti-clockwise)
• C to return to the previous menu then
• programme row 5977 (Function input H5) then
B
• B None B
B) FLOW TEMPERATURE MODULATION
• Access menu 2.
•
B Temps / mode CH1
• B (anti-clockwise)
temperature, parameter 742
• Access menu 2 as indicated at the beginning of this section.
• B
• B Yes then B
ZONE SYSTEM WITH INSTALLATION OF THE REMOTE CONTROL
The electrical connection and the adjustments required to manage a system divided into zones with use of the Remote Control
Module supplied as an accessory.
SYMBOLS FOR REMOTE CONTROL
3 Engineer
4
OEM
C.
as follows:
B
B.
Room unit 1 B
B
742 (HC1). Proceed as follows:
B
"---" then B
B
B B programme row 6200 then
Display shows
Press button A and knob B together
Press buttons A and C together
B.
B
742 (Flow temp setpoint room stat)
B
B.
35
B
Expansion
7690785.01 (1-05/18)