Table of Contents
Advertisement
Installing a system or expansion unit into a rack
You might need to install a system or expansion unit into a rack. This section includes procedures so that
you can perform these tasks.
The following procedures describe how to install system units or expansion units into a rack. You can
perform this task or contact a service provider to perform the task for you. You might be charged a fee
by the service provider for this service.
Installing the 50/95 or 05/9511D/20 expansion unit into a rack
You might need to install an expansion unit into the rack. Use the procedure in this section to perform
this task.
This procedure assumes that you are installing the model 50/95 or 05/9511D/20 expansion unit into an
existing rack. If the rack is not installed, go to the instructions for "Installing the rack" on page 197 and
then return to this procedure for instructions on installing the system unit into the rack.
Note: This procedure applies only to the models that are designed to be mounted in a rack. Do not
attempt to install a stand-alone model in a rack.
To install the 50/95 or 05/9511D/20 into a rack, complete the following steps:
1. Read the "Rack Safety Notices" on page 245.
2. Unpack the template and rack hardware.
Figure 175. Unpacking the rack template and hardware.
222
Customer-Installable Features for the 17M/MA
Advertisement
Table of Contents
