Graco E-Flo DC Series Instructions - Parts Manual page 15

Flow Mode
When in flow mode, the motor will maintain a
constant speed regardless of the fluid pressure, up
to the pump's maximum working pressure. See
Technical Data, page 33.
1. See Fig. 13. Turn the Control Knob (N) fully
counterclockwise to 0.
2. Pull the Mode Select switch (M) out to set. Turn
the switch to Flow
lock.
3. The amount of flow is determined by the cycle
rate set with the Control Knob (N). The knob's
scale (0–10) corresponds to a cycle adjustment
range of 0-30 cycles per minute. Turn the Control
Knob (N) clockwise to increase the cycle rate
(flow), or counterclockwise to decrease the cycle
rate (flow).
3A2526D
. Push the switch in to
Figure 13 Flow Mode
Operation
15