Producing The Steam; Filling The Water Compartment (Manually); Filling The Water Compartment (Automatically) - Sawotec MINI COMBI Manual

pRoduCING THE STEAM

• Throwing water on the stones increases the moisture level inside the Sauna Room
and the heater increases the temperature.
• The amount of water thrown on the stones determines the moisture content of the
air.
• Three ladles of water at a time are enough to enjoy the Sauna. Throwing too much
water on the stones may cause scalding water to splash on the bathers, as the water
may not evaporate immediately.
• Make sure there is no one sitting near or next to the heater before throwing water
on the stones.

fILLING THE wATER CoMpARTMENT (MANuALLy)

Water can be poured through the openings underneath the scent basins or by removing
the steamer cover first (See page 11). The capacity of the tank is 2,5 liters. If water
in the tank exceeds the liter mark on the level indcator (except Trendline models), water
from the indicator tube end might spill on the floor. The water level can easily be mon-
itored through the water level indicator. If FILL appears on the external control unit's
display, cold household tap water shall be poured through the openings underneath the
scent basins by carefully removing the scent basins.
CAuTIoN: Streamer cover and scent basins are very hot if the heater is in use. Do not
touch them by bare hand. Always before turning on the steamer, make sure that sufficient
amount of water is in the tank.

fILLING THE wATER CoMpARTMENT (AuToMATICALLy)

An automatic refilling system makes it possible to produce steam without interruptions.
The tank will automatically be refilled when the water level reach the low water detection.
As a security feature, if there is no refill of an empty tank, the low water detection system
will automatically turn off the steamer heater. A FILL message is displayed together with
a buzzer tone on the external unit. If there is a valve on the water supply make sure it is
turned on position before turning steamer on. After refilling water, the steam generator
heater turns on again after a short while. The buzzer will stop alarming when water is
filled, or when the heating element is not hot anymore. The water level
in the tank can easily be monitored through the water level indicator.
All operations are handled through the external control unit. Choose either a normal bath
or a steam sauna bath. For normal sauna baths switch OFF the steamer. For steam sauna
baths switch ON the steamer. The steamer system will automatically start to produce
steam. To ensure ideal humidity, the sauna temperature should be 40 - 50°C. Before a
bath the steamer should be left on for about 30 minutes to pre-heat the sauna and pro-
duce sufficient amount of steam. When FILL appears on the external control unit's display,
water is automatically filled into the water tank. After every sauna bath the water tank
must be drained.
13
ENGLISH