Handling And Installation; Unpacking Procedures; Handling Precaution; Hardware Setup - GE V7865 Series Hardware Reference Manual

1 • Handling and Installation
This chapter describes the unpacking procedure; hardware setup; connectors,
headers and switches; installation; system setup and operation of the V7865.

1.1 Unpacking Procedures

Any precautions found in the shipping container should be observed. All items
should be carefully unpacked and thoroughly inspected for damage that might
have occurred during shipment. The board(s) should be checked for broken
components, damaged printed circuit board(s), heat damage and other visible
contamination. All claims arising from shipping damage should be filed with the
carrier and a complete report sent to GE Intelligent Platforms Customer Care.

1.2 Handling Precaution

Electronic assemblies use devices that are sensitive to static discharge. Observe
anti-static procedures when handling these boards. All products should be in an
anti-static plastic bag or conductive foam for storage or shipment. Work at an
approved anti-static workstation when unpacking boards.

1.3 Hardware Setup

The V7865 is factory populated with user-specified options as part of the V7865
ordering information. For option upgrades or for any type of repairs, contact
customer care to receive a Return Material Authorization (RMA).
GE Intelligent Platforms Customer Care is available at: (1-800-433-2682), or
+1-780-401-7700 for international calls.
Or, visit our website at:
The V7865 is tested for system operation and shipped with factory-installed
header jumpers. The physical locations of the jumpers and connectors for the SBC
with the PMC option are illustrated in Figure 1-1 on page 18. The definitions of
the connectors, headers and switches are included in Table 1-1 on page 19.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
www.ge-ip.com
CAUTION
All jumpers marked User Configured in the following tables may be changed or
modified by the user. All jumpers marked Factory Configured should not be
modified by the user.
Care must be taken when making jumper modifications to ensure against
improper settings or connections. Improper settings may result in damage
to the unit.
Modifying any jumper not marked User Configured will void the Warranty and
may damage the unit.

Handling and Installation 17