Security Setup - GE V7865 Series Hardware Reference Manual

B.6 Security Setup
The ezPORT setup provides both a Supervisor and a User password. If you use
both passwords, the Supervisor password must be set first.
The system can be configured so that all users must enter a password every time
the system boots or when ezPORT setup is executed, using either the Supervisor
password or the User password.
To reset the security in the case of a forgotten password you must drain the
NVRAM and reconfigure.
To clear the CMOS password:
When power is reapplied to the unit, the CMOS password will be cleared.
73 V7865 Hardware Reference Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Main Advanced PCIPnP
Security Settings
Supervisor Password :
User Password :
Change Supervisor Password
Change User Password
Clear User Password
Boot Sector Virus Protection
Hard Disk Security
NOTE
Options shown may not be available on your system.
• Turn off power to the unit.
• Momentarily short pins of E11 for approximately five seconds.
• Power up the unit.
BIOS SETUP UTILITY
Boot Security
Not Installed
Not Installed
[Disabled]
v02.59 (C) Copyright 1985-2005, American Megatrends, Inc.
Chipset Exit
Install or Change the
password.
←→
Select Screen
↑↓
Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit