Advertisement
Step 3: Fit upper part
Step 4: Lay flat cable
Step 5: Replace T splitter
4
15 cm
► Place the upper part.
► Tighten the fixing screws (4)
alternately.Tightening torque 2.5
Nm.
► Remove protective cap from the
M12 socket (5) and fix the M12
connector on the cable using the
coupling nut. Tightening torque
0.5...0.8 Nm.
► Lay flat cable; straight for a
minimum of 15 cm.
► If necessary, use AS-i clips (6).
AS-i clips are not supplied with
the unit. Information at
www.ifm.com → Data sheet
E70354 → Accessories.
► Note on replacement:
Precisely use the pierced points of the
AS-i flat cable (7) or at least position
within the black seal (8) of the T
splitter.
Advertisement
