Handling And Lifting - Gree A Series Installation, Start-Up And Maintenance Manual

When there is damager or any other question, contact the local sales representative for
applicable solutions.
After the acceptance check, take necessary protection to the unpacked equipment. Note
that it is not recommended to unpack the equipment too early to avoid any unexpected
damage.
5.3

Handling and Lifting

Each unit will undergo a series of strict factory inspections and tests to guarantee the
expected performance and quality. However, special attention should be paid during handling
and shipping to prevent the control system and the piping system from being damaged.
The unit should be moved by the forklift or hoisting machine. During lifting, the canvas lifting
or steel ropes in use should be of enough strength and go through the based and then bundled
tightly. The unit should be lifted stably from four corners. Meanwhile, be sure there should be
protective pads to prevent lifting ropes contacting with the unit. The inclination angle during
lifting should be less than 15 degree. The unit should be moved softly and severe collision and
forced drag are not allowed. Please do lifting as shown in the figure below for units with similar
structure.
A Series Inverter Modular Air-cooled Chiller (Heat Pump)
NOTE
11