Table of Contents
Advertisement
Image 4-1
Main switch
-
When '0' is pressed, the projector is switched off.
-
When 'I' is pressed, the projector is switched on.
The projector starts up to standby mode. The Power on/off button will blink until standby mode is achieved. Once in standby
mode, the Power on/off button will be lit WHITE, but the display will be off.
2. Press the Power on/off button on the projector, or the Power On button on the remote control.
The projector will continue to power on mode. The Power on/off button will blink until the projector is ready. Once the projector
is ready, the Power button will be lit BLUE.
The start up screen is displayed on the touch panel and when fully started up, it changes to the overview screen.
1
2
Image 4-2
The current mains input voltage is indicated on the voltmeter just above the power switch.
The background image of the startup screen and info screens can be changed with Projector Toolset with an
installed Pulseplug-in.
Status overview
Once the projector is started, press Status to get an overview of parameters such as :
R5906102 WODAN 15/02/2017
4. Getting Started
23
Advertisement
Table of Contents
