Related Manuals for Aaeon UP Vision Plus X
Summary of Contents for Aaeon UP Vision Plus X
- Page 1 UP Vision Plus X UPCP-CR-VPX3-A10-001 Maker Board User’s Manual 1 Last Updated: November 18, 2019...
- Page 2 AAEON assumes no liabilities resulting from errors or omissions in this document, or from the use of the information contained herein. AAEON reserves the right to make changes in the product design without notice to its users.
- Page 3 Acknowledgement All other products’ name or trademarks are properties of their respective owners. Microsoft Windows is a registered trademark of Microsoft Corp. ⚫ Intel, Pentium, Celeron, and Xeon are registered trademarks of Intel Corporation ⚫ Core, Atom are trademarks of Intel Corporation ⚫...
- Page 4 Packing List Before setting up your product, please make sure the following items have been shipped: Item Quantity UP Vision Plus X ⚫ Adapter Board i ⚫ Adapter Board ii ⚫ Cooler Heatsink ⚫ Standoff ⚫ Screw ⚫ If any of these items are missing or damaged, please contact your distributor or sales representative immediately.
- Page 5 (if any), its specifications, dimensions, jumper/connector settings/definitions, and driver installation instructions (if any), to facilitate users in setting up their product. Users may refer to the product page on AAEON.com for the latest version of this document. Preface...
- Page 6 Safety Precautions Please read the following safety instructions carefully. It is advised that you keep this manual for future references All cautions and warnings on the device should be noted. Make sure the power source matches the power rating of the device. Position the power cord so that people cannot step on it.
- Page 7 If any of the following situations arises, please the contact our service personnel: Damaged power cord or plug Liquid intrusion to the device iii. Exposure to moisture Device is not working as expected or in a manner as described in this manual The device is dropped or damaged Any obvious signs of damage displayed on the device...
- Page 8 FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
- Page 9 This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 10 China RoHS Requirements (CN) 产品中有毒有害物质或元素名称及含量 AAEON Main Board/ Daughter Board/ Backplane 有毒有害物质或元素 部件名称 铅 汞 镉 六价铬 多溴联苯 多溴二苯醚 (Pb) (Hg) (Cd) (Cr(VI)) (PBB) (PBDE) 印刷电路板 ○ ○ ○ ○ ○ ○ 及其电子组件 外部信号 ○ ○ ○ ○ ○ ○...
- Page 11 China RoHS Requirement (EN) Poisonous or Hazardous Substances or Elements in Products AAEON Main Board/ Daughter Board/ Backplane Poisonous or Hazardous Substances or Elements Hexavalent Polybrominated Polybrominated Component Lead Mercury Cadmium Chromium Biphenyls Diphenyl Ethers (Pb) (Hg) (Cd) (Cr(VI)) (PBB) (PBDE) PCB &...
-
Page 12: Table Of Contents
Table of Contents Chapter 1 - Product Specifications..................1 Specifications ......................2 Chapter 2 – Hardware Information ..................3 Dimensions ....................... 4 Jumpers and Connectors ..................5 List of Switches and Connectors................6 2.3.1 SIM Card (SIM1) .................... 7 2.3.2 Docking I (CN1) .................... -
Page 13: Chapter 1 - Product Specifications
Chapter 1 Chapter 1 - Product Specifications... -
Page 14: Specifications
Specifications System Intel Movidius Myriad X VPU x 3, MA2485 Intel WGI211AT PCI-E Gigabit Ethernet x 1 Ethernet Power Requirement 12V5A Power Supply Type 12VDC from M/B Power Consumption (Typical) Max 25W 90 x 56 mm Dimensions (L x W) 0 ~ 60°C (32 ~ 140°F) Operating Temperature 10 ~ 80% relative humidity, non-condensing... -
Page 15: Chapter 2 - Hardware Information
Chapter 2 Chapter 2 – Hardware Information... -
Page 16: Dimensions
Dimensions Chapter 2 – Hardware Information... -
Page 17: Jumpers And Connectors
Jumpers and Connectors Top side Bottom side Chapter 2 – Hardware Information... -
Page 18: List Of Switches And Connectors
List of Switches and Connectors Please refer to the table below for all of the board’s jumpers that you can configure for your application Reference Function Connector Type (TF)Micro SIM Socket.8P .SMD.Hinge SIM1 SIM CARD Type.REGO.80440GIH-081T-12CL (TF)Board-Board DOCKING I Connector.100P .180D(F).SMD.Pitch=0.5mm.H=6.05mm. Panasonic.AXK5S00347YG (TF)Board-Board DOCKING II... -
Page 19: Sim Card (Sim1)
2.3.1 SIM Card (SIM1) Signal Signal UIM_PWR UIM_RST UIM_VPP UIM_CLK UIM_DAT 2.3.2 Docking I (CN1) Signal Description Signal Description +V5A_CON +V5A_CON +V5A_CON +V5A_CON +V5A_CON +V5A_CON +V5A_CON +V5A_CON Chapter 2 – Hardware Information... - Page 20 Signal Description Signal Description PLTRST_N SLP_S3#_3P3 PCIE_CLKREQ3# Chapter 2 – Hardware Information...
- Page 21 Signal Description Signal Description I2C_SDA0 I2C_SCL0 I2C_SDA1 I2C_SCL1 VPU_EN ISH_GPIO_13 ISH_GPIO_14 Chapter 2 – Hardware Information...
-
Page 22: Docking Ii (Cn2)
2.3.3 Docking II (CN2) Signal Signal +12V +12V +12V +12V +12V +12V +12V +12V PCIE_REFCLK0_P PCIE_REFCLK1_P PCIE_REFCLK0_N PCIE_REFCLK1_N PCIE_RXP0 PCIE_RXP1 PCIE_RXN0 PCIE_RXN1 Chapter 2 – Hardware Information... - Page 23 Signal Signal PCIE_TXP0 PCIE_TXP1 PCIE_TXN0 PCIE_TXN1 PCIE_REFCLK2_P USB3_P4_TXP PCIE_REFCLK2_N USB3_P4_TXN PCIE_RXP2 USB3_P4_RXP PCIE_RXN2 USB3_P4_RXN PCIE_TXP2 PCIE_TXN2 SATA_RXN0 SATA_RXP0 USB2_DP3 SATA_TXP0 USB2_DN3 SATA_TXN0 USB2_DP4 USB2_DN4 PLT_RST# Chapter 2 – Hardware Information...
-
Page 24: Usb 3.0 Dual Port (Cn3)
Signal Signal PCIE_WAKE0_N PCIE_CLKREQ0# PCIE_WAKE1_N PCIE_CLKREQ1# PCIE_WAKE2_N PCIE_CLKREQ2# 2.3.4 USB 3.0 Dual Port (CN3) Signal Signal +V5A_USB +V5A_USB USB2_DN3 USB2_DN4 USB2_DP3 USB2_DP4 USB3_RXN_P3 USB3_RXN_P4 USB3_RXP_P3 USB3_RXP_P4 USB3_TXN_P3 USB3_TXN_P4 USB3_TXP_P3 USB3_TXP_P4 Chapter 2 – Hardware Information... -
Page 25: Mini Pcie Card (Cn5)
2.3.5 Mini PCIe Card (CN5) Signal Signal WAKE _MINI_N MINIPCIE_3.3V +V1.5S UIM_PWR UIM_DAT PCIE_REFCLK1_N UIM_CLK PCIE_REFCLK1_P UIM_RST UIM_VPP PWR_EN PLTRST# PCIE_RXN1/SATA_RXP0 MINIPCIE_3.3V Chapter 2 – Hardware Information... -
Page 26: Fan (Cn7)
Signal Signal PCIE_RXP1/SATA_RXN0 +V1.5S PCIE_TXN1/SATA_TXN0 PCIE_TXP1/SATA_TXP0 USB2_DN5 USB2_DP5 MINIPCIE_3.3V MINIPCIE_3.3V mSATA_PCIe_SEL +V1.5S MINIPCIE_3.3V 2.3.6 Fan (CN7) Signal +V5A Chapter 2 – Hardware Information... -
Page 27: Docking Iii (Cn8)
2.3.7 Docking III (CN8) Signal Signal +V1.8S I2C0_SCL_1P8 I2C0_SDA_1P8 PM_SLP_S3#_3P3 PCIE_CLKREQ3# VPU_EN ISH_GPIO_13 ISH_GPIO_14 Chapter 2 – Hardware Information... -
Page 28: Lan Port (Lan1)
2.3.8 LAN Port (LAN1) Signal Signal LAN1_TMDI0+ LAN1_TMDI3+ LAN1_TMDI0- LAN1_TMDI3- LAN1_TMDI1+ LAN1_LED_1000# LAN1_TMDI2+ LAN1_LED_100# LAN1_TMDI2- LAN1_ACTLEDN LAN1_TMDI1- LAN1_ACTLEDP Chapter 2 – Hardware Information... -
Page 29: Chapter 3 - Drivers Installation
Chapter 3 Chapter 3 – Drivers Installation... -
Page 30: Driver Download And Installation
Driver Download and Installation *Please access https://www.up-community.org and go to the Downloads section to find the relevant driver. Chapter 3 – Drivers Installation...