Table of Contents
Advertisement
How to Setup Tyco/Elpas
7.2
Installing the DLA card in the M166CL
Use the following procedure to install the DLA card.
PROCEDURE:
Actions
1.
Make sure that your M166 is type M166CL. If not, you cannot install the DLA card.
2.
Make sure tha the M166 is switched off.
3.
Open the rear side of the M166CL by means of removing the two screws as shown
in the following picture:
Remove two screws to get access to
4.
Mount the DLA card on to the M166, as shown in the picture below.
Note: Please be very careful in installing the DLA in the M166.
Note: The holes in the DLA card should fit over the rings in the M166, as shown in the
picture below.
Note: There are 6 pins on the DLA that should fit into the six pins connector in the
M166.
Note: Do not use force.
© NEC Nederland B.V. 2015
How to install the DLA in the M166
the DLA compartment.
Page 46
M166 CE Manual
Advertisement
Table of Contents
