Getting Started; Installing The Microsd™ Card; Installing The Battery Pack; Installing The Charger - NEC G966 Basic User's Manual

2

Getting started

2.1 Installing the microSD™ card
1. Open the protective cover on the underside of the G966 and insert the microSD™
card into the slot. Ensure that the logo of the microSD™ card is facing upward.
2. Close the protective cover.
2.2

Installing the battery pack

1. Place the handset face down on a flat surface.
2. Place both thumbs firmly at the top of the battery compartment cover and at the same time
shift the cover downwards.
3. Remove the battery compartment cover.
4. Push the battery pack into the casing.
5. Replace the battery cover.
2.3

Installing the charger

1. Place the charger on a flat surface.
2. Connect the micro-B USB connector of the USB cable to (the back of) the charger.
3. Connect the type A USB connector to the USB AC/DC Adapter.
4. Connect the adapter to an electrical outlet.
5. Place the handset on the charger as shown in Figure 1.
2.4

Charging the batteries

Power might not turn on the G966 if the battery voltage is too low or battery is discharged. In
that case, charge the battery with the desktop charger for at least ten minutes. It is
recommended that you charge the battery fully before you use the G966.
Figure 1: G966 Desktop Charging Rack