Installing The Mem Card - NEC G355 User Manual

Attention: Dropping the handset can in some cases cause a MEM
card not to be correctly installed in the handset anymore.
When this happens the user will be warned by audible
warning signals every 5 seconds, and the message
Check memory card
card properly in the handset!
When inserting a MEM card with the configuration of some other G355,
G955 or I755 DECT Handset then that configuration will be used.
Any configuration changes or new contacts, messages, calendar items
and call filter items added after installing a MEM card are stored on the
MEM card and not in the handset memory.
The MEM card feature is optional. You can operate your handset
without a memory card. An installed MEM card allows you to
personalise the handset and retain subscriber data. The MEM card
feature makes the data transfer easier when you change to another
handset.
You must remove the battery pack before you can remove or install the
MEM card. Reinstall the battery pack after you remove or install the
MEM card. For more information about removing the battery pack, see
Installing the battery pack (page
battery pack on the back of the handset.
Note: To install the MEM card into the handset, you must extract it from
the frame.

Installing the MEM card

To install the MEM card in the handset, perform the following steps:
1. Place the handset facedown on a flat surface.
2. Remove the battery compartment cover (for the G355 and
G955) and the battery.
3. Slide in the MEM card from under the two small crescents and
press it, as shown in
4. Ensure that you have inserted the MEM card completely.
5. Replace the battery pack.
6. G355 and G955: Replace the battery compartment cover.
Handset accessories
is given. Please insert the MEM
26). The MEM card tray is under the
Figure 19.
203