Table of Contents
Advertisement
B button
Use this to move the cursor left or select an item that
is to the left of the current item.
V button
Use this to move the cursor up or select an item that
is above the current item.
BACK button
Use this to return to a previous screen during menu or
operation screen displays.
When you press this button while nothing is
displayed on the screen, the text that appears on the
front panel display will be hidden.
Before using the remote control unit
Remove the insulation sheet.
To replace the lithium battery
Use a Sony CR2025 lithium battery. Do not use any other
type of battery with the remote control unit.
1
While holding in the lock lever (1), pull out the
battery holder (2).
2
Insert the replacement battery with the positive (+)
side facing up (1), and reinsert the battery holder
until it clicks into place (2).
Insulation sheet
Positive (+) side facing up
2
1
Warning
Batteries shall not be exposed to excessive heat such as
sunshine, fire or the like.
Caution
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
When you dispose of the battery, you must obey the law
in the relative area or country.
Battery lifetime
When the lithium battery output falls, even button presses
may not operate. The average lithium battery lifetime is
about one year, but this depends on the pattern of use. If
pressing the remote control buttons produces absolutely
no effect on this unit, replace the battery, then check the
operation again.
Status Displays
The following information is displayed when the status
display settings are enabled.
The status display settings are configured in the [System
Admin Settings] screen – [Function Settings] screen –
[General 1] tab. For details on this setting, see "[General
1] Tab" (page 69).
Rec status display / idle status display
Rec status displays
26
Advertisement
Table of Contents
