Table of Contents
Advertisement
Function Settings
Configure initial settings for patient information, input
signals, and other functions.
1
Select [Function Settings] in the [System Admin
Settings] screen, and press the ENTER button.
The [Function Settings] screen appears.
2
Select a tab, and press the ENTER button.
3
Configure the settings in each tab as necessary.
For details on each tab, see the following.
[Patient Info.] Tab (page 67)
[Input Signal 1] Tab (page 67)
[Input Signal 2] Tab (page 67)
[Recording] Tab (page 68)
[Auto Live] Tab (page 69)
[General 1] Tab (page 69)
[General 2] Tab (page 70)
[Facility] Tab (page 70)
[CMS] Tab (page 71)
4
When you finish configuration, select [Apply] and
press the ENTER button.
The configurations are saved, and the [System Admin
Settings] screen appears again.
[Patient Info.] Tab
Configure initial settings for patient information.
[Patient ID Length]
Select the number of digits to use for patient IDs.
You can select from 4 to 16 digits.
The default setting is [8].
[Add 0 to Patient ID]
Select whether to add zeros to patient IDs with less than
the specified number of digits.
The default setting is [Use].
[Patient Name Field]
Select the number of display fields to use for the patient
name.
If you select [2] or [3], the patient name field will be
separated into first, middle, and last names.
The default setting is [1].
[Change Patient Info.]
Select whether to allow changes to patient information at
any time.
The default setting is [Not Used].
[Input Signal 1] Tab
Configure initial settings for input signals.
[Region]
You can select from [NTSC] and [PAL].
The default setting is [NTSC].
[I/O Timing]
Select from [Normal] or [Pass-Through] for the input and
output timing.
Select [Normal] as signal processing is usually performed
under normal circumstances. There will be a slight delay
in signal outputs when [Normal] is selected.
Select [Pass-Through] for simultaneous input and output
timing without signal processing.
The default setting is [Normal].
[Input Detect Duration]
Select from 0 to 3 seconds for the duration for which input
signals are detected.
The default setting is [3 sec].
Note
Image distortion may occur if a duration of 2 seconds or
less is selected.
[3D Line by Line Signal]
When inputting 3D line-by-line signals, select [L First]
(left image) or [R First] (right image) for the first line.
The default setting is [L First].
[Input Signal 2] Tab
Configure initial settings for input signals.
[Ch1 IN Signal Display]
Select the check boxes for the input signals that will
appear as options in the Ch1 input signal selection screen.
(Multiple selections can be made.)
More than one input signal must be selected.
67
Advertisement
Table of Contents
