Maintaining The Sun Fire V40Z Server; Tools And Supplies Needed - Sun Microsystems Sun Fire V20z User Manual

4
C H A P T E R
Maintaining the Sun Fire V40z
Server
This chapter describes how to add, replace and configure components in the Sun Fire
V40z server after it has been set up.
Caution – Before touching or replacing any component inside the server, disconnect
all external cables. If possible, place the server on a grounded electrostatic-discharge
(ESD) pad and ALWAYS wear a properly grounded, antistatic wrist strap.
For instructions on maintaining a Sun Fire V20z server, see Chapter 3.
This chapter contains the following sections:
"Tools and Supplies Needed" on page 4-1
■
"Powering Off the Server and Removing the Cover" on page 4-2
■
"Locations of Sun Fire V40z Components" on page 4-3
■
"Customer-Replaceable-Unit Replacement Procedures" on page 4-12
■
"Sun Fire V40z Indicators, Switches and Jumpers" on page 4-78
■
To determine and isolate a faulty component, refer to the Sun Fire V20z and Sun Fire
V40z Servers—Troubleshooting Techniques and Diagnostics Guide (817-7184).
4.1

Tools and Supplies Needed

#2 crosshead screwdriver
■
Antistatic wrist strap
■
Alcohol pads (for CPU replacement only)
■
4-1