Quick Start Guide
MIP-LCD
Expansion Board
Pmod1
Connector
MIP-LCD(Parallel)
Connector
USB Serial
DC Power Jack
(5V)
Power LED
Note: An active internet connection is required for downloading IAR Embedded Workbench
Use IAR Embedded Workbench® Ver 8.40.2 or above.
1. Installation of IAR Embedded Workbench
a. Free version of IAR Embedded Workbench
limited (30days) version and code size limited version. The sample code provided on the Renesas website can be
run on a code size limited version.
https://www.iar.com/iar-embedded-workbench/#!?architecture=Arm
If you would like to purchase the full version, please contact us in the following URL.
https://www.iar.com/buy/
b. Run the downloaded installer. Follow the instructions to install IAR Embedded Workbench
necessary to select the driver corresponding to the emulator to be used. Since J-Link OB is used this document,
select the J-Link driver.
2. Download Sample Code
c.
The sample code is available for download from the following URL. Download to the root of any drive on your PC. In
this document, R_GDT driver sample code
representative example. Download the R_GDT driver sample code
d. When the download is complete, unzip the file.
Pmod2
USB
Connector
Host
User Switches
User LEDs
®
(Using CMSIS Driver Package)
https://www.renesas.com/ek-re01-1500kb
Evaluation Kit RE01 1500KB
USB
Solar Panel
Func
Interface
Reset Switch
MD Switches
RE01 Headers
are available for download from the following link. There are time
J-Link OB
Connector
Emulator
Connector
Super Capacitor
Arduino UNO Interface
Potentiometer
®
. During installation, it is
®
(R01AN4755EJ) is used as a
(Using CMSIS Driver Package)
Solar Panel
®
and sample code.
(R01AN4755EJ).