Using The Sunswift Sbus Adapter And Existing Ethernet Interface - Sun Microsystems SunSwift 600MP series Installation And User Manual

1.3.2 Using the SunSwift SBus Adapter and Existing Ethernet Interface

# pkgadd -a none -d /cdrom/solaris_2_5_sparc/s0/Solaris_2.5 SUNWhmd SUNWhmdu
9. Power off your system, using standard shutdown procedures described in
Solaris 2.5 Handbook for SMCC Peripherals.
10. Install the SunSwift SBus Adapter as described in Chapter 2.
You will be installing software from the Solaris 2.5 CD-ROM. Make sure the
Solaris 2.5 CD-ROM is properly placed in the CD-ROM drive before
performing the following tasks.
If you want to use the SunSwift SBus Adapter Ethernet interface and your
existing Ethernet interface, you must perform the following tasks before
installing the SunSwift SBus Adapter.
Note – Make sure you have an Ethernet cable for each Ethernet interface.
1. As superuser, add the SUNWhmd and SUNWhmdu packages to your system:
2. For both packages, answer / to the following question:
Enter path to package directory [?,q]
You will receive a message stating the process was successful.
3. Assign an IP address and host name for the SunSwift SBus Adapter
Ethernet channel.
For example, 123.456.78.90 (IP address); zardoz (host name).
4. Edit the /etc/hosts file and add an entry containing the new IP address
and host name for the selected hme channel.
This is the IP address and host name that you assigned in step 3.
Preparing for Installation
1
1-5