Changing Engine Oil - Hisun HS1P65MM Operator's Manual

IMPORTANT:
Visually check the muffler for cracks or

holes in the body, welds or pipes at regular
intervals.
USDA approval

between spark arrester sleeve and muffler
body to be no larger than 0.023"(0.584
mm).
Replace the entire muffler if it is damaged.

Do not operate the vehicle with a

damaged muffler.
① Muffler ② Gasket
③ Spark arrester ④ Bolt
EVERY 200 HOURS

■ Changing Engine Oil

CAUTION
To avoid personal injury:

Be sure to stop the engine before
replacing oil.

Allow engine to cool down sufficiently,
oil can be hot and can burn. oil can be
hot and can burn.
1. Park the vehicle on flat surface and
remove the seat, open the adjust hatch
cover.
Periodic Service
requires clearance
10-13
2. To drain the used oil, remove the drain
plug at the bottom of the engine and
completely drain the oil into an oil pan.
3. After draining, reinstall the drain plug.
4. Fill with the new oil up to the upper notch
on the dipstick.
(See "LUBRICANTS,
COOLANT" in "MAINTENANCE" section.)
[Filter exchanged]
Oil capacity
[Filter non-exchanged] 1.0L (1.68U.S. qts.)
① ② Oil level is acceptable within this range ~
③ Dipstick ④ Oil inlet
① Drain plug
FUEL AND
0.8L (1.89U.S. qts.)