Parceltools C190 CubetapePRO Technical Manual page 25

3.
(1) The name of Task can be edited.
(2) Enable Barcode Scanning should show a scanning window during application.
See Figure 3-10. The maximum number of barcodes is 3. The barcodes number will be on
the top left corner of display. Move out the tick to disable this operation in application.
Figure 3-10
(3) Enable to Enter should show Piece window during application. See Figure 3-11. Set the
maxim piece number, which can be entered via application. Move out the tick to
disable this operation in application.
(4) This configuration is only available in Weigh Task. Choose the needed
scale from the pull down list.
(5) Dimensioning Measurement should be always enabled for most applications except Ship.
The operation windows shows on Figure 3-12.
Figure 3-9
Figure 3-11
Figure 3-12
Technical manual-C190CubetapePRO
Figure 3-13
24