Bosch Rexroth AG
Standards
Observe the following special conditions for a safe operation of the
devices and components:
The explosion protection approval applies only to the components
●
XFE01.1-FB-03 and XFE01.1-FB-20.
The explosion protection approval is only valid if the devices and
●
components approved by Bosch Rexroth are used as intended, re-
fer to
The components may only be used together with the devices and
●
accessories approved by Bosch Rexroth. Otherwise, the explosion
protection approval does not apply.
In case of unintended modifications at the device or at the com-
●
ponents, the explosion protection approval does also not apply.
For maintenance and troubleshooting, refer to
tenance" on page 28
shooting" on page
The components may only be used in an area with the minimum
●
pollution degree 2 as defined in IEC 60991-1.
For the permitted ambient temperature range, refer to
●
"Ambient conditions" on page
The components may only be installed in a housing (control cabi-
●
net) providing at least an ingress protection of IP54 in compliance
with IEC 60079-0.
Take suitable actions to ensure that the supply voltage outside the
●
device or the component is always within the permitted voltage
range (±10%) acc. to EN 60079-0.
Maintenance and repair work may only be carried out by the certi-
●
fied Rexroth service.
Always store and transport the device or the component in the
●
original package.
DANGER
Working at the components is only permitted if there is no explosive atmos-
phere.
DANGER
Do not exceed the ambient temperature permitted, refer to
conditions" on page 7
12/37
chapter 4 "Intended use" on page
and
26.
Explosion hazard
Explosion hazard when exceeding or falling be-
low the ambient temperature
Extension Modules Profibus, RT-
Ethernet, Sercos, CAN
5.
chapter 13 "Error causes and trouble-
7.
DOK-CONTRL -XFE**EXTMOD-IT04-EN-P
chapter 14 "Main-
chapter 6
chapter 6 "Ambient