Advertisement
TROUBLESHOOTING
No indication
No power to the machine
Only water instead of coffee comes
when «Powder coffee» is selected
Coffee is not hot enough
No hot water / steam
Hot water / steam nozzle blocked
Heating time too long,
not enough water
Brewing unit cannot
be removed
Brewing unit cannot
be inserted
Restore brewing unit to
original position
Preparation does not start
Display:
= The motor of the grinding unit
is blocked
= No beans
= Ventilate machine
= Fresh water tank empty
= Dregs drawer missing
= Dregs drawer full
(after 14 coffees)
= Request for descaling
= Request for cleaning
after 250 coffees
= Temperature too high
= Brewing unit blocked
= Brewing unit missing
= Door open
- Switch on main switch
- Check plug and power connection
- Fill up a measure of powder coffee
- Pre-heat cups
- Possibly clean brewing unit, descale if
necessary
- Clean nozzle with needle
(when the machine is switched
off and tap is closed)
- Descale machine
1. Close service door
2. Switch on machine
3. Brewing unit is unlocked
4. Where appropriate, continue maintenance
of brewing unit, see page 9
1
2
Contact the Service technician
Refill with beans
See page 1, ventilate
Fill water tank with fresh water
Insert dregs drawer
Empty dregs drawer (with machine switched on)
See page 6, descale
Note: coffee can still be prepared
See page 6, clean
Note: coffee can still be prepared
See page 1, Ventilate
See page 8, Troubleshooting (Brewing unit)
Insert brewing unit
Close door
8
CLEANING
- The machine must not be connected to main switch for cleaning.
- Do not use conventional and / or microwave ovens for drying the coffee machine components.
Casing
Container for coffee grounds and
drip tray
Water tank
Coffee outlet
Clean weekly
Brewing unit
Clean weekly.
Never clean the brewing unit
in the dishwasher!
2.1 Loosen sieve with key...
2.2 ...and remove
Use a mild non abrasive cleaning agent!
Wipe with a soft, damp cloth
Rinse under running water
Rinse under running water
Remove the filter that is in the water tank and
rinse thoroughly. Replace by turning and pressing
lightly into place.
1. Place receptacle under coffee outlet
2. Press button «Coffee powder»
(do not fill in coffee powder)
3. Let flow pure water through the system
to avoid residuals in the pipes etc.
1. Open service door.
Remove drip tray / grounds container
2. Press PUSH-position and remove
brewing unit. If necessary, unscrew the
uppermost sieve in the brewing unit
Clean everything under running warm water
and let it dry. Clean service area
3. Reassemble brewing unit and
slide in,
do NOT press the PUSH-
position!
4. Insert drip tray and grounds container,
then close service door
9
Advertisement
