HP 9000 300 Series Installation Reference page 19

I
CAUTION
I
Turn your computer OFF before installing the monitor.
I
CAUTION
I
Do not obstruct the air vents at the top and sides of the monitor.
Check the voltage select setting.
Your monitor has a voltage select switch. Make sure that the monitor is set to the same
voltage range as the computer.
Find the video cables.
The video cable carries video signals from the computer to the monitor. Your monitor
has three separate video cables for red, blue and green. The cables are identical and may
be used for any color.
Connect the video cables.
The video cables are color-coded Red, Blue and Green. The monitor output connectors
are labelled R, Band G. Connect each video cable connector to the appropriate video
connector on the computer. Then connect the other ends of the cables to the Monitor.
Install the audio cable.
Now find and install the audio cable.
It
has an RCA connector on each end. Install it
between the computer and the monitor.
Install the HP-HIL cable.
The HP-HIL cable is keyed.
It has a black dot at one end and two black dots at the
other.
Locate the two-dot end of the HP-HIL cable.
It is marked with two black dots.
Connect the two-dot end of the HP-HIL cable to the computer. The computer socket is
also coded with two dots.
Connect the one-dot end of the HP-HIL cable to the monitor. The monitor receptacle is
also coded with one dot.
Installing Your System 11