HP 9000 300 Series Installation Reference page 17

I
CAUTION
I
Turn your computer OFF before installing the monitor.
I
CAUTION
I
Do not obstruct the air vents at the top and sides of the monitor.
Check the voltage select setting to be the same as the computer.
Your monitor has a voltage select switch. Make sure that the monitor is set to the same
voltage range as the computer.
Find the audio/video cable.
A two-conductor cable is furnished for audio and video. One conductor is marked "Video"
at each end and the other is marked "SPKR".
Connect the audio/video cable.
Connect one end of the "Video" cable to the Video Out connector on the computer.
Connect one end of the "SPKR" cable to the Audio Out connector on the computer.
Then connect the other ends to the monitor.
Install the HP-HIL cable.
The HP-HIL cable is keyed. It has a black dot at one end and two black dots at the
other.
Locate the two-dot end of the HP-HIL cable. It is marked with two black dots.
Connect the two-dot end of the HP-HIL cable to the computer. The computer socket is
also coded with two dots.
Connect the one-dot end of the HP-HIL cable to the monitor. The monitor receptacle is
also coded with one dot.
Installing Your System 9