HP 9000 300 Series Installation Reference page 14

Hide thumbs Also See for 9000 300 Series:
Table of Contents

Advertisement

Position the Computer to Allow Free Air Flow
Leave enough clearance at the back of the computer for any cables that will be connected.
If pressure is exerted against the computer-end of these cables, the connector could be
damaged.
Open the long box and remove the power cord.
The long box is called the Localization Kit. and contains items such as power cords,
keyboard cables, and this manual.
Compare the voltage setting to the power cord.
Your computer can be set to operate at nominal line voltages of 120 or 240 Vac. It was
set at the factory to the line voltage in your area. However, it is a good idea to check
the setting and change it if it is incorrect.
I
CAUTION
I
The computer can be damaged if set for 120 Vac and plugged into
a higher voltage.
The best way to check for correct setting is to determine whether you have the correct
power cord, then use the furnished chart to determine the correct setting for the power
cord.
6
Installing Your System

Advertisement

Table of Contents
loading

This manual is also suitable for:

9000 series350330300 series320318 ... Show all

Table of Contents