First Startup - Axis 2N Indoor Touch 2.0 User Manual

2.5 First Startup

When you start the device for the first time, the initial initialisation (longer start) is
performed and indicated by the following LED notification sequence:
Boot animation on the screen Introductory system screen.
The introductory screen provides essential information for User Manual saving
/reading. Select "Don't show welcome screen and run
instead" to deactivate this screen for future system startups.
Caution
If you do not select the "Don't show welcome screen and run 2N
Mobile
quitting and then enable the
startup in the Launcher configuration, the application will not be started
for technical reasons. Therefore, be sure to disable the welcome screen
start to make
The table below shows the factory values of relevant device parameters:
Parameter
IP address
IP mask
IP gateway
Access password to configuration
Administrator password
Time/weather location
Stand-by switching time
SW licence
2N TELEKOMUNIKACE a.s., www.2n.cz
at next start instead" option on the welcome screen before
®
2N IP Mobile
Value
will be assigned by the DHCP server
will be assigned by the DHCP server
will be assigned by the DHCP server
2n
2n
Prague, CZ
1 minute
Basic unlimited licence
2N
®
2N IP Mobile launch after the system
run automatically after the system startup.
Red Blue
®
IP Mobile at next start
22/135
Green
®
IP