Configuring Status Picture "Pcs 7 Sfc Topology Control - Siemens SIMATIC PCS 7 Programming And Operating Manual

Configuration

5.8 Configuring status picture "PCS 7 SFC Topology Control"

5.8 Configuring status picture "PCS 7 SFC Topology Control"
Introduction
The states of an SFC can be output to a graphic picture by means of an PCS 7 SFC Topology
Control which is assigned to this SFC. To this, you place and configure the status picture in a
graphic picture in the WinCC Graphics Designer.
Placing the PCS 7 SFC Topology Control in the graphic picture
Open the desired graphic picture in the Graphics Designer.
● If you have performed the preparation for the controls, use drag-and-drop to drag the "PCS 7
SFC Topology Control" from the "Controls" object palette to the picture. You can find
additional information in the section: Preparing the controls (Page 19)
● If the controls are not yet in the object palette, proceed as follows:
– Select the following entry in the "Smart Objects" tool palette.
– Draw a frame in the graphic picture for the object to be placed.
– Select "PCS 7 SFC Topology Control".
Assigning parameters
1. Double-click the PCS 7 SFC Topology Control.
The "Properties" dialog box opens.
2. Open the "General" tab.
3. In the "Connected SFC" field, configure the corresponding SFC to be displayed in the
control.
To do this, click on the button to the left of the text box to open a selection dialog.
4. Select the desired SFC and then close the dialog box with "OK".
5. Select the relevant option in the "Display mode" area.
6. Close the dialog box with "OK".
Note
As in previous versions, you can also use the Dynamic Wizard to configure the status picture.
24
The selection list of all installed "Controls" will be displayed.
Programming and Operating Manual, 05/2017, A5E41356392-AA
SFC Visualization (V9.0)