Siemens SIMATIC PCS 7 Programming And Operating Manual page 39

– "Ready to complete" status display, when the SFC is not self-terminating (SELFCOMP
– The status display of the sequencer after CPU startup
– The display for an interconnection error (or empty box)
– The display for an operator error (or empty box)
– The display for a step error (or empty box)
– The display for an operator prompt (or empty box)
– The button for group acknowledgement
The buttons:
– For selecting "MANUAL" or "AUTO" mode
– For enabling changeover to "AUTO"
–
–
–
–
–
–
–
–
The check boxes for enabling and disabling the execution options "command output",
"cyclic execution", and "time monitoring".
SFC Visualization (V9.0)
Programming and Operating Manual, 05/2017, A5E41356392-AA
= 0) and is waiting in the run state for the "Complete" command (display, if READY_TC
= 1).
Note
To view "Continuous mode" and "Ready to complete", refer to the screenshot in the
section: "SFC chart" faceplate, "SFC section" view (Page 34).
Start (only active in the "Prepared values" view)
Hold
Resume
Abort
Complete
Stop
Restart
Reset
6.5 "SFC Instance" faceplate, "Actual Values" view
Startup with consistent data or
Startup with inconsistent data
Operating and monitoring SFCs
39