. This will not detract from the output current rating of the Eaton PH and PV as the current rating of the Eaton PH and PV is based on the output current only .
Eaton PH device . Wire from the overcurrent protection device to the input terminal(s) of the Eaton PH device . The terminals are marked L, N, and G . Wire gauge should be selected to match the amperage of the overcurrent NOTICE protection device .
Page 4
Instruction Manual IM01005022E Installation Instructions for Eaton Surge Protective Device xxPHxxxxx and xxPVxxxxx Effective April 2014 Figure 2. Eaton PH Premium Hybrid Filter Bonded System Block Diagram. Figure 3. Eaton PH Premium Hybrid Filter Unbonded System Block Diagram. EATON www.eaton.com...
Enclosure Mounting (Existing Aegis VL Wiring Instructions Eaton PV - Install an overcurrent protection device on the input side of the Eaton PV . Wire the overcurrent pro- applications) tection device to the input terminal(s) of the Eaton PV . The terminals are marked L, N, and G .
Page 6
Instruction Manual IM01005022E Installation Instructions for Eaton Surge Protective Device xxPHxxxxx and xxPVxxxxx Effective April 2014 Figure 5. Eaton PV Premium Filter Bonded System Block Diagram. Figure 6. Eaton PV Premium Filter Unbonded System Block Diagram. EATON www.eaton.com...
**Register products on-line at www.eaton.com/spd. Then click on “Warranty Registration”. Diagnostics Maintenance The Eaton PH and PV are supplied with a green LED that will illumi- Preventive Maintenance (Inspection and Cleaning) – Periodic nate and indicate power at the output terminals . If the green LED is...
15 years if the product is properly registered with Eaton, to be free from defects in both workmanship and materials . Eaton assumes no risk or liability for results of the use of the products purchased from it, including but without limiting...