Siemens SIMATIC IPC327E Operating Instructions Manual page 77

Improper operations on the motherboard may result in substantial damage to the
motherboard or endanger the operator.
• Do not remove or ruin the motherboard serial number labels.
• Wear electrostatic discharge (ESD) wrist strap or gloves when handling or touching the
• When handling the motherboard, avoid to touch any metal leads or connectors.
• Always unplug the AC power cord from the power outlet before you installing
• Place the motherboard on an anti‐static pad or in a electrostatic shielding container
• Turn off the power supply before you removing the power supply cable from the
• Before turning on the power supply, check if the input voltage setting follows
• Before operating the motherboard, make sure that the cables and the
• Make sure you securely attached the hardware components to the motherboard
• The screws are not allowed to connect with motherboard circuit or components. The
• Do not leave the screws or the metal components on the motherboard or inside of the
Setting Jumpers
The board has a number of jumpers that allow you to configure. A jumper is a kind of electric
switch. By setting jumpers, you can configure your card to match the needs of your
application.
A jumper consists of two metal pins and a small metal clip (often protected by a plastic
cover).
To connect the pins, lid the pin with the clip. To disconnect a jumper, remove the clip. Some
jumpers have three pins, labeled 1, 2 and 3. In this case you can connect either pins 1 and 2
or 2 and 3.
A pair of needle nose pliers may be helpful when working with jumpers. If you have any
questions about the best hardware configuration for you application, contact your local
distributor or sales representative before you make any change.
SIMATIC IPC327E
Operating Instructions, 06/2019, A5E40965257-AD
WARNING
These labels and the serial numbers are required for warranty validation.
motherboard.
or removing the motherboard.
during the operation.
motherboard.
the local voltage standard.
power connectors of all the attached hardware components are connected.
Turning on the power before you connected them, the motherboard and the system
components may get damaged and injure operator.
connectors/ slots/ sockets.
motherboard can be get damaged by this action.
chassis.
Appendix Motherboard
A.1 Jumpers
77