Installation And Electrical Connection; Housing Cover - Gira 5201 00 Manual

3. Installation and electrical connection

3.1. Housing cover

2 1
1
1
4 3
1.
LAN N L
N L
2.
3.
LAN N L
N L
Order No. 5201 00
1
2 1
Position 1
Position 0
Position 2
Position 1
Position 0
Installation and electrical connection
1 Housing cover (closed = position 0)
2 Status LED (under housing cover)
The alarm control unit only operates with the housing
cover closed.
1 Mounting holes
2 Opening for mains power cable
3 Opening for Ethernet cable
4 Disconnecting surface for tamper contact
Position 0
Housing cover closed (factory settings). After connection
to the battery pack and 230 V as well as project commis-
sioning:
Housing cover closed = operating mode.
Position 1
Push the housing cover up until the screws of the hinged
cover are exposed and the housing cover is noticeably
blocked. Loosen the two screws in the hinged cover and
push the housing cover further up (this position can only
be achieved with the screws are loosened!). The housing
cover can be removed.
Position 2
Housing cover removed = configuration mode.
Only the upper mounting holes and the slot of the GSM
module are accessible when the hinged cover is closed.
When the hinged cover is open, all connections (battery
pack, LAN, telephone, etc.) and the mounting holes are
accessible.
Page 6