Related Manuals for Xylem Bell & Gossett WEHT0311M
Summary of Contents for Xylem Bell & Gossett WEHT0311M
- Page 1 INSTRUCTION MANUAL IM249R03 High Temp Sump Pump INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS...
-
Page 2: Table Of Contents
TABLE OF CONTENTS SUBJECT PAGE Introduction .................................... 3 Safety Instructions .................................. 3 Performance and Motor Details ............................3 Pre-Installation Checks ................................3 Lifting of Pump ..................................4 Optional Guide Rail or Lift-Out System ..........................4 Piping ...................................... 4 Wiring and Grounding ................................4 Selecting and Wiring Pump Control Panels and Switches .................... -
Page 3: Introduction
INTRODUCTION aged equipment, provide unsatisfactory performance, and may void manufacturer’s warranty. Bell & Gossett High Temperature 3885 Series Effluent Standard units are not designed for use in pumps are recommended for use in High Temperature WARNING swimming pools, open bodies of water, applications up to 200ºF. -
Page 4: Lifting Of Pump
The oil should be within ½” (13mm) of the top. If low, refill Install an adequately sized gate valve AFTER the check valve with an ASTM 150 turbine oil. Replace the plug. for pump, plumbing and check valve maintenance. Oil is available in 5 gallon cans through our distributors. You Important –... -
Page 5: Installation
SETTING THE FLOAT SWITCHES SINGLE PHASE CONTROL PANELS: There are no absolute rules for where to set the float switch- Control panels are available as Simplex (controls 1 pump) or es, it varies from job to job. Duplex (controls 2 pumps). Our standard SES Series Panels are available with many standard features and can be built Suggested Rules to Follow: with our most popular options. -
Page 6: Float Switch And Panel Chart
floats by filling the wetwell with clear water. Important: performance at the exact rated nameplate frequency and Failure to provide a Neutral from the power supply to a 1Ø, voltage. Correct the problem before proceeding. Three 230 volt Control Panel will not allow the panel control circuit phase unbalance is also a possible cause. -
Page 7: Insulation Resistance Readings
INSULATION RESISTANCE READINGS Normal Ohm and Megohm Values between all leads and ground Condition of Motor and Leads Ohm Value Megohm Value A new motor (without drop cable). 20,000,000 (or more) 20 (or more) A used motor which can be reinstalled in well. 10,000,000 (or more) 10 (or more) Motor in well. -
Page 8: Troubleshooting
TROUBLESHOOTING FAILURE TO DISCONNECT AND LOCKOUT ELECTRICAL WARNING POWER BEFORE ATTEMPTING ANY SERVICE CAN CAUSE Hazardous SHOCK, BURNS OR DEATH. voltage SYMPTOM PROBABLE CAUSE RECOMMENDED ACTION MOTOR NOT RUNNING Motor thermal protector tripped. Allow motor to cool. Insure minimum pump submergence. -
Page 9: Typical Installations
TYPICAL INSTALLATIONS Typical Effluent, Sewage and Dewatering Pump Installations... - Page 10 NOTES...
- Page 11 NOTES...
-
Page 12: Limited Warranty
2881 East Bayard Street Ext., Suite A Seneca Falls, NY 13148 Phone: (866) 325-4210 Fax: (888) 322-5877 www.xylem.com/bellgossett Bell & Gossett is a trademark of Xylem Inc. or one of its subsidiaries. © 2019 Xylem Inc. IM249 Revision Number 3 March 2019...