Advertisement
1. B
S
EFORE
TARTING
Open the gate behind the device (Figure 1), and find the power input on the right side of the terminal. Connect
the plug from the power adapter into the power input (Figure 2). Plug the power adapter into a 120-volt
electrical outlet or into a surge suppressor (recommended) after the power cord is connected to the power
adapter.
Operating Temperature: 0 °C to 40 °C
Modem Speed: V.22bis 2400bps/ V.32bis 14400bps
RTC battery spec. : 3V, CR2032
Adaptor: Delta Electronics Inc,ADP-36PH B, I/P: 100-240Vac,50-60Hz, 1A,O/P: 12Vdc,3.0A, LPS.
* Power Adapter: DC 12V, 3A(Output Rating)
(Use only the XAC Automation Corporation provided AC adapter approved for use with this device.
Use of another AC adapter may cause a fire or explosion)
Caution: The cover (Figure 5) shall be provided with a means to keep it closed during normal operation.
Caution: Risk of explosion if the battery is replaced by an incorrect type. Please dispose of used battery
according to the instructions.
Warning: A shielded-type power cord is required in order to meet FCC emission limits and also to prevent
interference to the nearby radio and television reception. It is essential that only the supplied power cord be
used.
Connect one end of the phone cord into one of the jacks on the back of the terminal (Figure 3). Plug the other
end of the cord into a modular wall jack (Figure 4). Use only a jack for an analog line like a fax line or a standard
telephone.
(Optional) This terminal supports three USB ports. Two USB host ports locate on the back of the terminal
(Figure 5). One USB device port locates on the left side of the terminal (Figure 6). If the terminal uses a
peripheral device with USB connector, plug it into the USB host port.
(Optional) This terminal supports one RS-232 ports of RJ-12 offset keyed connector. If the terminal uses a
peripheral device with this type of connector and interface, plug it into the RS-232 port on the back of the
terminal (Figure 7).
(Optional) If the terminal needs communication over Ethernet, plug cable into the RJ-45 port on the back of the
terminal (Figure 8).
(Optional)
The terminal supports GSM/3G M2M wireless communication and the SIM card slot locates on the
left side of the device (Figure 9).
function. Insert the SIM card into the SIM card slot (SAM 4) to communicate with GSM/3G (Figure 9). Make
sure SIM card is inserted in the right direction.
Figure 5
2. P
O
OWER
N THE
Plug the power cord into the power jack and plug the power adapter into a 120-volt electrical outlet or into a
Figure 1
Figure 3
There are 4 SAM slots on the left side and SAM 4 also supports SIM slot
Figure 8
T
ERMINAL
Figure 6
Figure 2
Figure 4
Figure 7
Figure 9
Advertisement
