VW Passat
1
2
1
3
5
4
Fig. 17
2
Fig. 18
1
2
3
Fig. 19
Heater Preparation/Installation
ATTENTION
Observe torque specifications.
Install heater mounting bracket with three EJOT screws.
Tighten EJOT screws to 10 Nm (88.5 lb.-in.).
– (1) Mounting bracket
– (2) EJOT screws
Install heater on existing vehicle studs with two nuts
provided. See figures 18 and 19.
– (1) Existing vehicle stud
– (2) Heater
– (3) Front drivers side tire
Secure heater by installing support bracket on heater and
existing vehicle stud.
– (1) Support bracket
– (2) Existing vehicle stud
– (3) Front drivers side tire
– (4) EJOT screws - 2ea.
– (5) Heater
13