Table of Contents
Advertisement
EN
12
Operation
6. OPERATION
6.1 SETTING THE MOWING HEIGHT
ATTENTION: Before setting the mowing height, always make sure that the lawnmower is turned off and
the blade is not moving.
ATTENTION: The blade will rotate for several seconds after the lawn mower is turned off. A rotating blade
can cause injuries.
The mowing height is set in 3 positions independently on the front and rear wheel axle.
1. position 25 mm
2. position 45 mm
3. position 60 mm
Fig. 4.1
Setting the height of the front wheels - pull the wheel away from the grass catcher and select the desired
height. Follow this procedure for both front wheels. Figure 4. 1
Setting the height of the rear wheels - pull the wheel towards the grass catcher and select the desired height.
The height should be the same as on the front wheels. Follow this procedure for both rear wheels. Figure 4. 1
ATTENTION: Make sure that the height of all 4 wheels is set the same
Note: Lawns of standard grass blends should not be mowed to less than 4 cm. Lawn should not be
shortened by more than 1/3 of its height.
6.2 CONNECTING TO THE POWER GRID
Insert the power cable plug into the power grid (230-240 V, 50 Hz).
Check that there is a suffi cient length of power cord available.
The quality of the power cord must not be lower than type H05RN-F or H05VV-F and must have a minimum
cross-section of 1.5 mm 2 and a maximum recommended length of 30 m.
6.3 TURNING THE LAWNMOWER ON/OFF
ATTENTION: Do not start the lawnmower when it is standing in a place with tall grass.
FZR 2014-E
Advertisement
Table of Contents
