Siemens Milltronics ILE-37 Application Manual page 6

Step Four: Replace Bushing Lock Nuts
1. Replace protective plastic ring on sensing plate side.
2. Replace the first bushing lock nut.
3. Hand tighten the first bushing lock nut, until it is snug
against the protective ring.
CAUTION: Do not over tighten!
Step Five: Replace Sensing Plate
1. Place shaft of sensing plate into
sensing head shaft socket.
2. Push inward and twist sensing plate
until it cannot move further.
CAUTION: Do not use hammer or excessive force!
Milltronics ILE-37 Sensing Head Diaphragm Replacement
3. Line up channel at end of sensing
plate shaft with roll pin and push shaft
into place.
4. Use 5 mm hex screwdriver or Allen
key to tighten the set screw.
AG050425
APPLICATION GUIDE
4. Replace second bushing lock nut.
5. Use 1 ¾" or 45 mm wrench, or adjustable wrench
to firmly tighten the second bushing lock nut.
5. Use 10 mm wrench to tighten the nut
holding the set screw in place.
roll pin
6 of 7