Siemens Milltronics ILE-37 Application Manual page 2

Step Two: Remove Sensing Plate
1. Use 10 mm wrench to loosen the nut
holding the set screw in place.
Step Three: Remove Bushing Lock Nuts
1. Use 1 ¾" or 45 mm wrench, or adjustable wrench to
remove the two bushing lock nuts, one at a time.
Milltronics ILE-37 Sensing Head Diaphragm Replacement
2. Use 5 mm hex screwdriver or Allen
key to loosen the set screw.
AG050425
APPLICATION GUIDE
3. Remove the sensing plate by twisting
shaft back and forth, while pulling
outward.
CAUTION: Do not use hammer or excessive force!
2. Remove protective plastic ring.
2 of 7