Replacing A Tail/Brake Light Bulb Or A Rear Turn Signal Light Bulb - Yamaha FreeGo LTK125 2019 Owner's Manual

Periodic maintenance and adjustment
Replacing a tail/brake light
bulb or a rear turn signal light
bulb
If a tail/brake light bulb or a rear turn
signal light bulb burns out, replace it as
follows.
Tail/brake light bulb
1. Remove panel B (with rear storage
compartment). (See page 7-8)
2. Remove the bulb socket (together
with the bulb) by turning it coun-
terclockwise and pulling the tail-
light bulb socket up at an angle.
7
1. Tail/brake light bulb socket
3. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
EAUN2410 4. Insert a new bulb into the socket
by pushing it in and turn it clock-
wise until it stops.
NOTICE
If a taillight bulb of different wattage
than recommended is used, it may
cause the battery to discharge or af-
fect the taillight lighting.
5. Install the bulb socket (together
with the bulb) by turning it clock-
wise.
6. Install the panel.
Rear turn signal light bulb
1. Remove panel B (with rear storage
compartment). (See page 7-8)
1
2. Remove the grab bar.
3. Remove the bulb socket (together
with the bulb) by pulling it out.
ECAU0091
1. Rear turn signal light bulb
4. Remove the burnt-out bulb from
5. Insert a new bulb into the socket.
NOTICE
If a turn signal light bulb of different
wattage than recommended is used,
the turn signal light flashing may be
affected.
6. Install the bulb socket (together
7. Install the grab bar.
8. Install the panel.
7-29
1
the socket by pulling it out.
with the bulb) by pushing it in-
ward.
ECAU0081