Yamaha FreeGo LTK125 2019 Owner's Manual page 52

Periodic maintenance and adjustment
TIP
The engine oil should be between the
tip of the dipstick and maximum level
mark.
1
1. Engine oil filler cap
7
2. O-ring
3. Engine oil dipstick
4. Maximum level mark
5. Tip of the engine oil dipstick
4. If the engine oil is at or below the
minimum level mark, add suffi-
cient oil of the recommended type
to raise it to the correct level.
5. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
To change the engine oil and clean
the oil strainer
1. Start the engine, warm it up for
several minutes, and then turn it
off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap
and drain bolt B to drain the oil
from the crankcase. NOTICE:
2
When removing the engine oil
3
drain bolt, the O-ring, compres-
4
sion spring, and oil strainer will
5
fall out. Take care not to lose
these parts.
1. Engine oil drain bolt A
2. Gasket
3. Oil strainer
4. Compression spring
5. O-ring
6. Engine oil drain bolt B
[ECA11002]
TIP
When only changing the engine oil, re-
move drain bolt A. When changing the
engine oil and cleaning the engine oil
strainer, remove drain bolt B also.
4. Clean the engine oil strainer with
7-11
2
1
solvent, and then check it for
damage and replace it if neces-
sary.
3
4
5
6