Yamaha FreeGo LTK125 2019 Owner's Manual page 56

Periodic maintenance and adjustment
3. Pull the air filter element out.
1. Air filter element
4. Insert a new air filter element into
the air filter case. NOTICE: Make
sure that the air filter element is
7
properly seated in the air filter
case. The engine should never
be operated without the air filter
element installed, otherwise the
piston(s) and/or cylinder(s) may
become excessively
[ECA10482]
NOTICE
The air filter element must be
replaced at the intervals speci-
fied in the periodic maintenance
and lubrication chart.
The air filter element needs
more frequent replacement if
you are riding in unusually wet
or dusty areas.
Do not clean the air filter ele-
ment by blowing it with com-
pressed air.
1
5. Install the air filter case cover by
installing the screws.
Cleaning the V-belt case check hose
worn.
1. V-belt case check hose
ECA21220
1. Check the hose on the rear side of
the V-belt case for accumulated
dirt or water.
2. If dirt or water is visible, remove
the hose from the clamp, clean it,
and then install it.
TIP
If dirt or water was found in the check
hose, be sure to check the V-belt case
air filter element for excessive dirt or
damage and clean or replace it if nec-
essary.
Cleaning the V-belt case air filter el-
ement
1. Place the vehicle on the center-
2. Remove the bolts, and then pull
1
1. V-belt case air filter element cover
2. Bolt
7-15
stand.
the V-belt case air filter element
cover outward and away from the
V-belt case.
2
1
2