Martin QC1 Operator's Manual page 2

Cleaner xhd with metal tipped blade.

Hide thumbs Also See for QC1:

Table of Contents

MARTIN ENGINEERING HEREBY DISCLAIMS ANY LIABILITY FOR: DAMAGE DUE TO

CONTAMINATION OF THE MATERIAL; USER'S FAILURE TO INSPECT, MAINTAIN AND TAKE

REASONABLE CARE OF THE EQUIPMENT; INJURIES OR DAMAGE RESULTING FROM USE OR

APPLICATION OF THIS PRODUCT CONTRARY TO INSTRUCTIONS AND SPECIFICATIONS

CONTAINED HEREIN. MARTIN ENGINEERING'S LIABILITY SHALL BE LIMITED TO REPAIR

OR REPLACEMENT OF EQUIPMENT SHOWN TO BE DEFECTIVE.

Observe all safety rules given herein along with owner and Government standards and regulations. Know

and understand lockout/tagout procedures as defined by American National Standards Institute (ANSI)

z244.1-1982, American National Standard for Personnel Protection - Lockout/Tagout of Energy Sources -

Minimum Safety Requirements and Occupational Safety and Health Administration (OSHA) Federal

The following symbols may be used in this manual:

Danger: Immediate hazards that will result in severe personal injury or death.

Warning: Hazards or unsafe practices that could result in personal injury.

Caution: Hazards or unsafe practices that could result in product or property damages.

Important: Instructions that must be followed to ensure proper installation/operation of equipment.

Important

DANGER

WARNING

CAUTION

IMPORTANT

NOTE

Note: General statements to assist the reader.

Table of Contents